Nowadays, there are many kinds of Stage light truss stage, but it needs some efforts to build a qualified aluminum stage, because the aluminum stage can add light to the wonderful performance, so what needs to be done in the process of building Stage light truss?
Building a uniquely designed stage with Stage light trusses not only provides a platform for performances or product displays, but also adds color to the event with its stylistic design, which plays a good role. As you can see, stage light truss construction is not just about building a stage, but about the design of the event itself, taking into account many factors. Today, Shizhan Group will talk about the precautions when building Stage light truss.
1.Stage light truss is not allowed to mix steel and bamboo, steel and wood, and not to mix fasteners, rope, wire, bamboo gabions and plastic gabions.
2. Ensure the integrity of Stage light truss, not to tie with derrick and lift at the same time, not to cut off the frame.
3. Stage light truss must be moved at a certain distance from the edge, and send someone to take care of it.
4. Stop the sudden movement of Stage light truss to speed up the movement, it must be smooth and slow trekking.
5. Stage light truss erection personnel must be licensed to work, and the correct use of safety helmets, safety belts, wear non-slip shoes.
In today's society, the use of Stage light truss is very common, both in production activities and in life. Stage light trusses have emerged to provide greater convenience to people in life and production activities, especially with the development of Stage light trusses there have been many types. But Stage light truss manufacturers reflect that the manufacturing process often directly affects the use of Stage light truss. So, how to effectively prevent Stage light truss in the production of deformation?
Here we will take some common forms of Stage light truss as an example to understand the specific situation. Stage light truss welding speed of aluminum is also the main factor to control the deformation, welding Stage light truss, glass curtain wall aluminum speed heat input is low will lead to greater expansion, and in the process of cooling shrinkage is also the opposite the greater.
Insufficient heat input for octagonal prisms can also lead to bad welding melt, producing a lack of penetration and unfused defects such as. Preheating of the weld beforehand can reduce the degree of deformation and tendency to cracking of Stage light truss products and can increase the Stage light truss welding speed. Excessive restriction of the welded structure during the cooling process may also lead to the creation of weld cracks.
The shape of the octagonal welding bevel and the amount of welding are the main factors affecting the deformation of Stage light truss, for the amount of welding deformation is usually much smaller than many welding V-bevel welding deformation. The molten state of aluminum Stage light truss and open frame glass curtain wall is about 6% of its volume during the solidification process, and the shrinkage stresses generated during this process may lead to deformation in the welded joint.
Shizhan Group would like to remind everyone that it is very important to effectively prevent the deformation of Stage light truss during the production process, therefore, it is important to take note of these elements so as to better provide consumers with good products.